Home > News > Content

The Basic Working Principle Of The Screw Pump

Apr 19, 2022

The screw pump uses the rotation of the screw to suck and discharge the liquid. FIG. 1 shows a cross-sectional view of a three-screw pump. In the figure, the middle screw is the driving screw, which is driven by the prime mover to rotate, and the screws on both sides are the driven screw, which rotates in the opposite direction with the driving screw. The threads of the main and driven screws are both double-ended threads.

Due to the mutual meshing of each screw and the close fit between the screw and the inner wall of the liner, one or more sealed spaces are separated between the suction port and the discharge port of the pump. With the rotation and meshing of the screw, these sealed spaces are continuously formed at the suction end of the pump, enclosing the liquid in the suction chamber, and continuously moving from the suction chamber to the discharge end along the axial direction of the screw, sealing the air in each space. The liquid is continuously discharged, just as a nut is continuously pushed forward when the thread rotates. This is the basic working principle of the screw pump.

The sealing surface between the screw and the casing is a space curved surface. There are non-sealing areas such as ab or de on this curved surface, and many triangular notches abc and def are formed with the groove part of the screw. These triangular notches constitute the channel of the liquid, so that the groove A of the driving screw communicates with the grooves B and C on the driven screw. The grooves B and C are wound to the back along their own spirals, and are respectively connected with the grooves D and E on the back. Since there is also a triangular gap a'b'c' similar to the front on the sealing surface where grooves D, E and groove F (which belong to the other end of the spiral) are connected, D, F, and E will also be connected. In this way, the groove ABCDEA also forms a "∞"-shaped sealing space (if a single-head thread is used, the groove will wrap around the screw in the axial direction, and the suction and discharge ports will pass through, and no seal can be formed). It is not difficult to imagine that many independent "∞"-shaped sealing spaces will be formed on such a screw, and the axial length occupied by each sealing space is exactly equal to the lead t of the exhaust rod. Therefore, in order to separate the oil suction and discharge ports of the screw, the length of the thread section of the screw must be at least greater than one lead.


Send Inquiry
Contact Us
    • Mob: 8618157769662
          Tel:0086-577-85859880  85859770  85859660
    • Email: info@oceanpumps.com   sales@oceanpumps.com
    • Add: No.33-1, Gangrong Road, Yongxing Street, Longwan District, Wenzhou City, Zhejiang Province, China