It is mainly composed of a bushing (pump cylinder) fixed in the pump body, a driving screw inserted in the pump cylinder and two driven screws meshing with it. The three intermeshing screws form a sealed cavity in the pump cylinder according to each lead, resulting in a seal between the suction and discharge ports.
When the pump is working, since the two driven screws and the driving screw are symmetrically meshed left and right, the radial force acting on the driving screw is completely balanced, and the driving screw does not bear the bending load. The radial force on the driven screw is supported by the pump cylinder bushing along its entire length, so there is no need for additional bearings at the outer end and basically no bending load. During operation, an oil film is formed between the outer surface of the screw and the inner wall of the pump cylinder, which can prevent the direct contact between the metals and greatly reduce the wear of the screw tooth surface.
When the screw pump is working, the suction and discharge pressures of the liquid act on the two ends respectively, so the axial thrust is generated on the screw. For small pumps with differential pressure less than 10 kgf/cm2, thrust bearings can be used. In addition, high-pressure oil is introduced into the bottom of each screw bushing through the central oil hole of the driving screw, thereby generating a balanced thrust opposite to the axial thrust at the lower end of the screw.
Like other positive displacement pumps, when the pump discharge port is completely closed, the pressure in the pump can rise to a dangerous level that damages the pump or overloads the motor. Therefore, a safety valve must be installed at the suction and discharge ports of the pump.
The shaft seal of the screw pump usually adopts a mechanical shaft seal, and can take different forms according to the working pressure.






