Preventive maintenance costs a fraction of an unplanned breakdown. This schedule works for typical single-stage water pumps (XA, XAW and similar) in clean-water service.
1. Daily / shift checks (operator, 5 minutes)
- Pressure and flow readings near normal;
- No unusual noise or vibration;
- No visible leaks at seal or casing;
- Packing drip rate (if packed) about 1 drop/second when running;
- Record readings in the logbook - trends warn before failures.
2. Monthly (maintenance)
- Check bearing temperature and lubrication level;
- Check motor current against nameplate; clean motor air vents;
- Inspect coupling for wear and re-check alignment if vibration appeared;
- Clean strainer / suction filter; test standby unit if installed.
3. Quarterly
- Lubricate bearings per manual (grease type and quantity matter - over-greasing overheats);
- Check mechanical seal no-leak; adjust/top up packing;
- Check shaft runout and coupling elastomer condition;
- Test automatic controls (pressure switches, vacuum priming cycle, engine sets).
4. Annually (inspection / overhaul)
| Task | Detail |
|---|---|
| Impeller & wear rings | Inspect for erosion/cavitation damage; measure clearances |
| Bearings | Replace if noise/play; check shaft 25–75mm journals on XA |
| Seal | Replace mechanical seal or repack the stuffing box |
| Alignment | Re-check after overhaul; re-tighten foundation bolts |
| Performance test | Compare flow/head/current to the original curve sheet |
Engine-driven sets (diesel fire pumps): add engine-specific service - oil and filter changes per engine hours, battery load test, fuel system check, and a full auto-start test monthly. A standby fire pump that cannot start is worse than no pump at all.
Need genuine spare parts or service guidance? Contact sales@oceanpumps.com with your pump serial number.






